Homemade Hand Warmer

Here’s a twist on the classic chemical hand warmers you can buy for you to research and improve.

If you’ve been outdoors when it’s really cold, there’s a good chance you’ve either used these yourself or wished you had. You can experience a variation on the science found inside a commercial warmer with some pretty basic materials. You’ll discover how an everyday chemical reaction like rusting is used to keep your digits toasty. This experimental version of the hand warmer is offered as a test idea and not as a definitive solution. You’re encouraged to share your science fair results online.

SICK Science® is a registered trademark of Steve Spangler, Inc. All Rights Reserved.

Experiment Materials

Experiment Videos

Experiment

1

Fill the plastic cup with water. If you have some, use distilled water for this Step. It’s optional, however.

2

Add a rounded quarter-teaspoon of dry Water Jelly Crystals to the water. That will be plenty. Really! These pebbles are a superabsorbent polymer and become huge when fully hydrated. Give them several hours or even over night to soak. If you have some soaked crystals left over, spread them on wax paper for a couple weeks and they’ll dry to their original size. You can also check the website for ways to use them.

3

After they’ve soaked and swelled up, dump four heaping tablespoons of the Crystals into the plastic bag. You may need to break them up a bit to make them more manageable.

4

Add a tablespoon of the iron filings to the Crystals in the bag.

5

Now add 1.5 tablespoons of the calcium chloride to the mixture in the bag.

6

Keep the bag open and carefully mix the contents by squishing it with your fingers. Move and mix the contents all around inside the bag. When you’re satisfied the contents are mixed, push the air out of the bag and seal it tightly.

7

With the bag sealed, press and squish it to mix the contents even more. By now, you’re probably feeling some serious heat coming from the bag.

How Does It Work

You know that leaving unprotected iron of any kind exposed to the elements outdoors will produce iron oxide or rust. All it takes is water in any form and the iron will be quickly covered in rust. A byproduct of the rusting process is heat. Hand warmers you buy usually have a porous pouch containing a mix of iron powder, activated charcoal, salt, and vermiculite. Activated charcoal is a very porous material that holds the water needed for the oxidizing (rusting) reaction to occur. Activated charcoal is also thermally conductive, which means it helps to spread heat evenly. The salt works as a corrosive material to help initiate the rusting process. Along with the activated charcoal, vermiculite helps diffuse the iron powder so the filings don’t get too hot too quickly and possibly burn your skin.

This experimental version is a little different from the commercial ones. The Crystals provide the water needed for the rusting process to occur. Instead of using ordinary table salt (sodium chloride), this version uses calcium chloride. It’s similar to the materiel used on icy roads but it’s much more corrosive. The theory is that the exothermic reaction (lots of heat) produced by calcium chloride and water will quick-start the oxidation of the iron powder. That’s the theory.

Again, this experimental version of the hand warmer is offered as a test idea and not as a definitive solution. You’re encouraged to share your science fair results online.

Science Fair Connection

Making your own hand warmer up is pretty cool, but it isn’t a science fair project. You can create a science fair project by identifying a variable, or something that changes, in this experiment. Let’s take a look at some of the variable options that might work.

  • How does adding more or less iron filings affect the length of the reaction?
  • If you use more or less calcium chloride, how might the length of the reaction or the temperature produced change?

That’s just a couple of ideas, but you aren’t limited to those! Try coming up with different ideas of variables and give them a try. Remember, you can only change one thing at a time. If you are testing different liquids, make sure that the other factors are remaining the same.

Related Products