Balloon Powered Car

1. Start off by cutting the chassis of your car. We don't condone the use of blow torches or saws during Sick Science experiments, so you have to create the chassis using scissors and foam core (corrugated cardboard works great, too). Cut a 6x3 inch piece of your chosen material using the scissors.
2. A car is nothing without axles. Given the size of your car, wooden barbeque skewers will make perfect axles. Use wire cutters to snip two 4" pieces of skewer.
3. You need to mount the axles to your chassis in a way that allows the axles to turn freely. For mounts, cut two 3" sections of straw and use tape to fix the mounts to the front and back (3" sides) of your chassis.
4. Now that you have axle mounts, mount your axles! Slide the wooden skewers through the middle of the straws.
5. Axles are great, but humans invented the wheel for a reason. The wheel was invented for use on the Balloon Powered Car! Use scissors to cut four quarter-sized pieces of regular cardboard. If it helps, you can trace a quarter or circle of similar size to give yourself some guidelines.
6. Push the cardboard circles onto the skewers, one on each end of both skewers. Without needing lug nuts or a compression wrench, you've mounted your wheels!

Anyone who has ever built a car from scratch will tell you that the engine is the most complicated piece, and the balloon powered car is no different. Hope you're ready!

1. Cut the mouth ring (the lip that you blow into) off of the balloon. This will allow for a better seal between the balloon and the exhaust pipe.
2. For the exhaust pipe, insert a straw approximately 1" into the balloon. Use tape to securely fasten the straw inside the balloon. The tighter the seal, the better your exhaust pipe is going to work, so make sure as little air as possible can escape.
3. Mount the exhaust pipe so that the point where the straw and balloon connect is about 1" from the end of your chassis. Taping it at this point is your best bet. Secure the straw so that it points straight out from the chassis.
4. Inflate the balloon and pinch the straw to keep air inside the balloon. Place the racer on the ground and let it go!

Make It Your Own!

There are a ton of things you can do to personalize and adjust your car:

• Make a fun design on your chassis to make it look funky and fresh (if that's what the kids are calling it these days).
• Adjust the size of your wheels to see if size affects the distance your car can go.
• Trim your straw or try different straw sizes to see which exhaust system supplies the most thrust.

How does it work?